APXII-300

0 out of 5

Amplifier for intensive use

  • Output power 2 x 100W @ 8-ohm / 2 x 150W @ 4-ohm
  • Built-in compressor-limiter
  • Mode selector: stereo, bridge & parallel
  • Built-in surge protection
  • Input & Output XLR/TRS connectors for signal routing

Description

APX-II 300 is a power amplifier with an output power of 2 x 100W @ 8-ohm / 2 x 150W @ 4-ohm and a built in compressor-limiter to protect your speakers. The amplifier comes with a stereo, bridge mono and parallel mono mode selector and built-in surge protection. On the rear APX-II 300 provides XLR/TRS input & through connectors for signal routing and speakon connectors for output wiring.

Additional information

Output power - Stereo 8-Ohm

2 x 100W

Output power - Stereo 4-Ohm

2 x 250W

Output power - Bridge 8-Ohm

1 x 300W

Input impedance

10kOhm balanceado a tierra

Frequency response

15Hz~25kHz

THD

<0.03%, +4 dBu @ 1 kHz, gain unit

Slew Rate

40V/uS

Signal to noise ratio

>102dB

Damping factor (1kHz@8Ohm)

>4001

Protections

Full short-circuit, Open-circuit, Thermal, Soft-Start, DC voltage, Sub/Ultrasonic and RF

XLR Connectors

2 XLR female balanced

TRS Connectors

2 6,35 mm. TRS Plug

Output

2 Speakon loudspeaker outputs

Terminals

2 pairs

Input sensitivity selection

0.77V / 1.0V / 1.44V

Selection mode

Parallel, Stereo, Bridge

Ground

Lift & Gnd

Cooling

2 Front-to-back via 2 variable-speed fans

Voltage range

AC100–240V, 50-60Hz

Max. Consumption

300W

Dimensions (mm)

482x289x88,8

Weight

8 Kg.