APXII-800

APXII-600
APXII-1200
0 out of 5

Amplifier for intensive use

  • Output power 2 x 250W@ 8-ohm / 2 x 410W @ 4-ohm
  • Built-in compressor-limiter
  • Mode selector: stereo, bridge & parallel
  • Built-in surge protection
  • Input & Output XLR/TRS connectors for signal routing

Description

APX-II 800 is a power amplifier with an output power of 2 x 250W @ 8-ohm / 2 x 410W @ 4-ohm and a built in compressor-limiter to protect your speakers. The amplifier comes with a stereo, bridge mono and parallel mono mode selector and built-in surge protection. On the rear APX-II 800 provides XLR/TRS input & through connectors for signal routing and speakon connectors for output wiring.

Additional information

Output power - Stereo 8-Ohm

2 x 250W
Output power - Stereo 4-Ohm

2 x 410W
Output power - Bridge 8-Ohm

1 x 820W
Input impedance

10kOhm balanced to ground
Frequency response

15Hz~25kHz
THD

<0.03%, +4 dBu @ 1 kHz, unit gain
Slew Rate

40V/uS
Signal to noise ratio

>102dB
Damping factor (1kHz@8Ohm)

>400:1
Protections

Full short-circuit, Open-circuit, Thermal, Soft-Start, DC voltage, Sub/Ultrasonic and RF
XLR Connectors

2 XLR female balanced
TRS Connectors

2 6,35 mm. TRS Plug
Output

2 Speakon loudspeaker outputs
Terminals

2 pairs
Input sensitivity selection

0.77V / 1.0V / 1.44V
Selection mode

Parallel, Stereo, Bridge
Ground

Lift & Gnd
Cooling

2 Front-to-back via 2 variable-speed fans
Voltage range

AC100–240V, 50-60Hz
Max. Consumption

800W
Dimensions (mm)

482x369x88,8
Weight

12 Kg.

APX-II 800 – Manual

APX-II Series – Brochure ESP

APX-II Series – Brochure ENG